Full of Whimsy and Rage Iron-On Embroidered Patch

Lay clean garment on a flat surface

Turn iron on. Make sure steam is off with no water in iron. Switch to cotton setting (typically higher temp.)

Place patch onto garment where desired. Place a towel (or cotton) cloth over the patch area.

Apply pressure with iron in circular motions 1-3 min. over patch area to ensure adhesion. Allow patch to cool.

Flip garment inside-out, apply direct heat with iron onto the areas until adhered. Allow patch to cool again.

Check that patch has adhered completely. Repeat steps 4-6 as necessary + enjoy!